BEFORE YOU START: Create a new folder on your network space, called “AUTOCAD_FINAL_CHALLENGE”. Save the following figures into this folder, call them drawing1.dwg, drawing2.dwg, etc.

THE CHALLENGE PROBLEMS: You may complete these in any order that you wish!

CHALLENGE PROBLEM 1: Page 907, Problem 9. (There is some math involved here to figure out some of the dimensions, don’t be afraid to use a calculator.)

CHALLENGE PROBLEM 2: Page 923, Problem 35.

CHALLENGE PROBLEM 3: Page 934, Problem 49. (Draw the FRONT of this figure and then dimension, change your PRIMARY UNITS to FRACTIONAL. Format for entering a fractional number in AutoCAD is "1-1/2" instead of "1.5".)

CHALLENGE PROBLEM 4: Page 904, Problem 6. (Make sure to draw in the R2.215 circle using the right side circle center. Lots of TTR circles in this problem. NO ARCs.)

CHALLENGE PROBLEM 5: Page 957, Problem 75. (Make sure to draw the polygon in the center of the figure with the proper orientation!)

CHALLENGE PROBLEM 6: Prove Your AutoCAD Prowess!: Page 906, Problem 8.

CHALLENGE PROBLEM 7: Prove your 3D AutoCAD Prowess!: Page 916, Problem 25. (If you wish to attempt this in Inventor instead, you may.)

CHALLENGE PROBLEM 8: Page 959, Problem 78.

CHALLENGE PROBLEM 9: Replicate the figure below as precisely as possible, using any appropriate AutoCAD commands.

.

CHALLENGE PROBLEM 10: Replicate the figure below as precisely as possible, using any appropriate AutoCAD commands

.

SUBMITTING YOUR WORK: Save all of your files to your “AUTOCAD_FINAL_CHALLENGE” on your network drive for the class.

GRADING: You will be graded on the precision and accuracy of the problems that you complete and the work ethic demonstrated to complete your work.