AutoCAD: The REVIEW Problems Assignment

BEFORE YOU START: Create a new folder in your AUTOCAD folder, called “lastname_AUTOCAD_review”. Save the following figures into this folder, call them drawing1.dwg, drawing2.dwg, etc. You have completed all of these problems in the past.

THE REVIEW PROBLEMS:

REVIEW PROBLEM 1: Page 77, Problem 1. Complete problem exactly as listed.

REVIEW PROBLEM 2: Page 33, Problem 1. Draw this figure. Please include DIMENSIONS.

REVIEW PROBLEM 3: Page 82, Problem 1. Draw the figure. Please include DIMENSIONS.

REVIEW PROBLEM 4: Page 119, Problem 2. Draw this figure. Please include DIMENSIONS.

REVIEW PROBLEM 5: Page 377, Figure 25-7. Draw and DIMENSION this figure. estimate the location of the center circle.

REVIEW PROBLEM 6: Page 920, Problem 31. Draw this figure. You do not have to DIMENSION this one.

REVIEW PROBLEM 7: Page 957, Problem 75. (Use FILLET where you can, in some cases, you might have to use TTR Circles and TRIM instead of using FILLET. Pay attention to the following two pieces of advice:

  1. Use the POLAR ARRAY COMMAND to create the center Octagon, see picture below. The CIRCLE that you will be creating for your Octagon has a DIAMETER of 1.5! You may need to ROTATE your OCTAGON when you are done, to match with the picture.)
  2. To connect the tangent line in the upper left corner, RIGHT CLICK on a toolbar and bring up the OBJECT SNAP toolbar (just like bringing up the DIMENSION toolbar.) Then click the following, in order:
    • the LINE command,
    • the SNAP TO TANGENT Object Snap pic3,
    • the first circle,
    • the SNAP TO TANGENT Object Snap pic2and
    • the second circle.

    This will draw the exact line needed to connect those two circles.

pic1

REVIEW PROBLEM 8: Page 912, Problem 19. Draw this figure. Make sure to set up your isometric grid properly and DIMENSION as in the book.

REVIEW PROBLEM 9: Page 980, Problem 101. Replicate this drawing. Include all of the small details of the kitchen and the bathroom. Label and DIMENSION as listed in the book.

SUBMITTING YOUR WORK: When you have completed all 9 problems, copy your entire “lastname_AUTOCAD_REVIEW” folder to the M: Drive Drop Box for your class period.

GRADING: This assignment will be included as part of the FINAL EXAMINATION for this semester.